久久综合久久美利坚中国_中曰韩无码视频_久久97久久97精品免视看_黄网址免费永久在线观看免费

顯微鏡物鏡加熱器OBJECTIVE HEATER

對顯微鏡物鏡進行加熱、保溫

Features

Temperature controlled heating band

Easy installation around the objective

Fits any objective on the market

Compatible with the following OKOLAB Controllers:

H301-T-UNIT-BL-PLUS

UNO-T-H-PREMIXED

UNO-T-H-CO2

H401-T-CONTROLLER

Compatible with Inverted and Upright Microscopes

Self CalibrationRoutines with BL controllers

Voltage: 24 V

Power: 13 W

When should I use an Objective Heater

You should use an objective heater， if you:

Perform Oil Immersion Imaging with a Top Stage Incubator

Use dipping lens with an upright Top Stage Incubator

Why should I use an Objective Heater?

Because， if you don't， sample temperature will drop due to oil contact with the cold objective， as shown in the following graph.

Step 1: Objective not in contact with Petri 2; Objective Heater Off.

Step 2: Objective in oil contact with Petri 2; Objective Heater Off.

Step 3: Objective in oil contact with Petri 2; Objective Heater on， Offset value 5.3°C.

During the self calibration routine， the offset value of the objective heater is progressively increased， until T2 reaches the desired set point temperature of 37.0°C.

Figure 3 reports the profile of T1， T2， and of Objective Heater Temperature during the experimental campaign described above.

請關注玉研儀器的更多相關產品。

如對產品細節和價格感興趣，敬請來電咨詢！