粉體行業在線展覽
煤炭行業專用儀器
安全防護用品
電化學儀器
儀器專用配件
光學儀器及設備
試驗機
X射線儀器
常用器具/玻璃耗材
氣體檢測儀
應急/便攜/車載
動物實驗儀器
臨床檢驗儀器設備
微生物檢測儀器
芯片系統
泵
分離/萃取設備
恒溫/加熱/干燥設備
清洗/消毒設備
液體處理設備
制樣/消解設備
磁學測量?jī)x器
燃燒測定儀
無損檢測/無損探傷儀器
半導體行業專用儀器
紡織行業專用儀器
金屬與冶金行業專用儀器
專用設備
石油專用分析儀器
橡塑行業專用測試儀
3D打印機
環境試驗箱
電子測量?jī)x器
工業在線及過程控制儀器
生物耗材
相關儀表
波譜儀器
輻射測量?jī)x器
水質分析
成像系統
分子生物學儀器
生物工程設備
細胞生物學儀器
植物生理生態儀器
純化設備
合成/反應設備
氣體發生器/氣體處理
實驗室家具
制冷設備
測厚儀
測量/計量?jī)x器
實驗室服務
其他
包裝行業專用儀器
建筑工程儀器
鋰電行業專用測試系統
農業和食品專用儀器
危險化學品檢測專用儀器
藥物檢測專用儀器
面議
368
DJC-1型單根電線電纜燃燒試驗儀中英文簡介
Two, product features
DJC-1單根電線電纜垂直燃燒試驗機是采用規定尺寸的本生燈 (Bunsen burner) 和特定燃?xì)庠?( 丙烷 ) ,按一定的火焰高度和一定的施焰角度對呈垂直狀態的試品定時施燃,以試品點燃、燃燒的持續時間和燃燒長度等來評定其可燃性及著火危險性。
The vertical burning test of DJC-1 single wire and cable is set by size Bunsen (Bunsen burner) and the specific gas source (Bing Wan), according to a certain flame height and some application of flame angle on the vertical state of the sample application to test ignition timing, ignition, combustion duration and combustion length evaluation the flammability and fire hazard.
Three, the main technical parameters
1.燃燒器:內徑Φ12mm ± 0.5mm(符合GB/T18380.11)及內徑Φ9.5mm ± 0.5mm(符合GB/T18380.21)本生燈各一個
1 burner: the inner diameter is Phi 12mm + 0.5mm (GB/T18380.11) and the inner diameter is 9.5mm + 0.5mm (GB/T18380.21) by a Bunsen burner
2.試驗傾角: 45°
2 test angle: 45
3.火焰高度:20mm ± 2mm 到190mm±1mm可調
3 flame height: 20mm + 2mm to 190mm + 1mm adjustable
4.施焰時間: 0-999.9s±0.1s可調
4 Shi Yan time: 0-999.9s + 0.1s adjustable
5.持焰時間: 0-999.9s±0.1s,自動記錄,手動暫停
5 flame holding time: 0-999.9s + 0.1s, automatic recording, manual pause
6.燃燒氣體: 95% 丙烷氣( 一般情況可采用液化石油氣代替 )
6 combustion gas: 95% propane gas (usually liquefied petroleum gas can be used instead)
7.流量壓力:帶雙流量表及壓力表(燃?xì)饧翱諝猓?/p>
7 flow pressure: with dual flow meter and pressure gauge (gas and air)
8.溫度測試范圍:0~1000℃
8 temperature measurement range: 0~1000
9.火焰溫度要求:從100℃±5℃升到700℃±3℃的時間在45秒±5秒之內
9 flame temperature requirements: from 100 to 5 degrees Celsius to 700 degrees Celsius 3 degrees Celsius in 45 seconds within 5 seconds
10.火焰應連續燃燒試樣,火焰燃燒時間T設定范圍0.1-999.9(秒)連續設定;
10 flame should be continuous combustion samples, flame burning time T set range 0.1-999.9 (seconds) continuous set;
11.測溫?zé)犭娕迹?#934;0.5mm進口鎧裝熱電偶(K型)
11 thermocouple: 0.5mm diameter imported armored thermocouple (type K)
12.試驗過程:試驗程序自動控制,無獨立抽風
12 test: test program automatic control, without independent exhaust
13.燃?xì)猓翰捎酶呒兌缺闅饣蚴鸵夯瘹猓ㄓ脩糇詡洌?/p>
13 gas: the use of high purity propane gas or liquefied petroleum gas (user owned);
14.被試驗電線電纜長度:600±25mm;
14 tested wire and cable length: 600 + 25mm;
15.被試驗電線電纜外徑:導體直徑大于0.8mm或截面積大于0.5mm2
15 the diameter of the test wire and cable: conductor diameter greater than 0.8mm or cross-sectional area greater than 0.5mm2
16.本裝置應安放在不通風且溫度為(23±10)℃的環境中進行試
16 the device should be placed in the environment without wind and temperature (23 + 10).
17.轉換開關可根據實際需要選用手動或自動;
17 switch can be selected according to the actual needs of manual or automatic;
18.燃?xì)饬髁糠秶?.1-1L/min;
18 gas flow range: 0.1-1L/min;
19.空氣流量范圍:0.1-1m3/h
19 air flow range: 0.1-1m3/h
20.燃燒噴燈標準功率:1KW;
20 standard combustion burner power: 1KW;
21.電源電壓:220V/50Hz
21 power supply voltage: 220V/50Hz
22.箱體材料:鋼板靜電噴涂/或不銹鋼機箱 外表無焊點工藝
22 case material: steel plate electrostatic spray / or stainless steel case appearance without solder joint process
23.工作室尺寸:300x450x1200mm(0.16立方)
23 studio size: 300x450x1200mm (0.16 cubic meters)
First, the scope of use
DJC-1單根電線電纜垂直燃燒試驗儀主要針對導體直徑大于8mm(截面積大于0.5mm2)或小于8mm(截面積小于0.5mm2)的單根電線電纜的可燃性能 進行評定。適用于照明設備、低壓電器、家用電器、機床電器、電機、電動工具、電子儀器、電工儀表、電氣連接件和輔件等電工電子產品及其組件部件的研究、生 產和質檢部門。
DJC-1 vertical burning tester for single wire and cable conductor diameter greater than 8mm (cross-sectional area greater than 0.5mm2 or less than 8mm) (cross-sectional area less than 0.5mm2) Combustible Properties of single cable were evaluated. Suitable for lighting equipment, low-voltage electrical appliances, household appliances, electrical tools, electric motor, electric tools, electronic instruments, electrical instruments, electrical connectors and accessories such as electrical and electronic products and components of the research, production and quality inspection department.
Four, with the cargo list
1 說明書 份 1
1 manual copy 1
2 燃燒箱 臺 1
2 combustion chamber 1
3 接物盤 件 1
3 receiving disc 1
4 保修卡 份 1
4 warranty card copy 1
5 合格證 份 1
5 qualified certificate 1
6 不銹鋼塊規 個 1
A 1 gauge stainless steel 6
Five, design standards
GB/T18380.11-2008、GB/T18380.12-2008、GB /T18380.21-2008、GB/T18380.22-
GB/T18380.11-2008, GB/T18380.12-2008, /T18380.21-2008 GB, GB/T18380.22-
2008、GB/T5169.14-2007
2008, GB/T5169.14-2007
Six, applicable standards
IEC60332 、 GB/T19666-2005、 GB12972 、 GB13033 、 MT818、MT386、ISO5656
IEC60332, GB/T19666-2005, GB12972, GB13033, MT818, MT386, ISO5656