久久综合久久美利坚中国_中曰韩无码视频_久久97久久97精品免视看_黄网址免费永久在线观看免费

The solution to silver wire decapsulation

The I53 Injector contains a 250 ml source bottle with double containment and leak detection. A single， small diameter， PTFE tube transfers the solution to the Elite Etch system. An injector block installed between the pump and heat exchanger of the Elite Etch and injects the solution into the acid stream. All components are PTFE， PCTFE， or borosilicate glass.

On an existing Elite Etch system， the I53 Injector can be easily installed using a new cable connected from the I53 to the Elite Etch. The existing handheld is now directly plugged into the I53 and does not require any special software for the etcher. The only modification to the etcher is the installation of the injector block and the routing of the solution tubing through the bottle box and into the I53.

When solution injection is selected from the handheld a set up cycle is initiated. This cycle fills the syringe pump and all of the tubing to， and including， the injector block. This cycle purges any excess solution to the waste bottle and prepares for etching with corrosion inhibiting solutions.

The injection of the inhibitor is initiated by selecting the appropriate operation recipe. The programming screen has a selection of the ratio with a range of 20:1 to 40:1. The injection ratio programmed applies to both etching and rinse. The syringe contains approximately 5 ml and the syringe and syringe plunger are easily replicable.

Specifications